Browse the workshop library
Projects & videos
Projects I’ve made, tools I’ve tested, and how I did it.
62 results
-
Easy project you can make AND SELL with ANY LASER! | Featuring @xToollaser S1 40W
I design and cut a simple personalized keychain on the xTool S1 40W, a quick beginner-friendly project you can make on almost any laser.
-
Is this the king of diode lasers? | @xToollaser S1 40W Unboxing and Review
I unbox the xTool S1 40W diode laser and test it on walnut, plywood, leather and slate to see whether it lives up to…
-
You won’t believe how easy it is to make this laser jig
I make a reusable laser jig in LightBurn so coasters and other repeat projects line up the same way every time.
-
Connecting to your laser with Lightburn over Ethernet – Easier than you think
I show how to connect a Ruida-controlled laser to LightBurn over Ethernet, which is easier than it sounds and only takes a few steps.
-
Unboxing the @monportlaser 80W CO2 laser engraver
I unbox and set up my Monport 80W CO2 laser, go over what comes in the box and fire it up for the first…
-
@monportlaser K40 vs @xToollaser 40W: Battle of the 40W lasers
I put a Monport K40 CO2 laser and an xTool 40W diode laser side by side on several materials to see where each one…
-
SUPER EASY project you can do with your @monportlaser #K40 laser TODAY
I make a quick customizable keychain on my Monport K40, a simple first project you can do on any CO2 laser.
-
Connecting your Monport K40 laser to Lightburn the easy way
I walk through connecting a Monport K40 CO2 laser to LightBurn, from picking the COM port to running a material test grid.
-
SO EASY – How to change your @monportlaser K40 CO2 Laser Tube
I walk through aligning the mirrors on my Monport K40 CO2 laser, routine maintenance that’s also needed after putting in a new tube.
-
Shop Vlog #0001 – Mini Shop Tour and What’s Going On at Created Workshop
I give a quick tour of the shop and talk through what I’m working on and what I want to do with Created Workshop…
-
Align Your Laser Mirrors in 3 Simple Steps For Better Cutting and Engraving
I break aligning the mirrors on a Monport K40 CO2 laser into three steps, so you can get better cuts and engraves.
-
Monport K40 40W CO2 laser with Lightburn unboxing and setup
I unbox and set up the Monport K40 40W CO2 laser with LightBurn, then test fire it and talk about how it compares to…
-
3 EASY Christmas present ideas you can make with your laser today
I make three easy, affordable Christmas gifts with my laser: slate coasters, wood ornaments and engraved charcuterie boards.
-
How to use Jinsoku LC-40 Rotary with Lightburn #laserengraving #lightburn #tutorial
I set up the Jinsoku LC-40 rotary with LightBurn, including the firmware and GRBL settings that aren’t well documented.